Dual-Cup Cupholder

$5.00

Cup holder designed originally for my Toyota T100 transmission tunnel. Can be used in a variety of vehicles with exposed transmission tunnels.

Provided is a 3d file.

Introducing the Dual-Cup Cupholder™ – Revolutionizing Road Refreshments.

Are you tired of balancing a Bartle Skeet in your lap while shifting gears? Fear not, the spirit of innovation is BACK, and it's here to hold your drinks and your dreams.

Perfectly Positioned for the Drive of Your Life!

With its slick design, the Dual-Cup Cupholder™ hugs your transmission tunnel like your tires sometimes do to the road. Whether you're cruising down the highway or tearing it up on the trail, your drinks stay steady, just like your trusty ‘95 Toyota.

For your cupholderless truck or car, this cupholder adapts to almost any transmission tunnel like a glove - always there, always reliable, and ready to hold the essentials

____

See below for SPECS.

Cup holder designed originally for my Toyota T100 transmission tunnel. Can be used in a variety of vehicles with exposed transmission tunnels.

Provided is a 3d file.

Introducing the Dual-Cup Cupholder™ – Revolutionizing Road Refreshments.

Are you tired of balancing a Bartle Skeet in your lap while shifting gears? Fear not, the spirit of innovation is BACK, and it's here to hold your drinks and your dreams.

Perfectly Positioned for the Drive of Your Life!

With its slick design, the Dual-Cup Cupholder™ hugs your transmission tunnel like your tires sometimes do to the road. Whether you're cruising down the highway or tearing it up on the trail, your drinks stay steady, just like your trusty ‘95 Toyota.

For your cupholderless truck or car, this cupholder adapts to almost any transmission tunnel like a glove - always there, always reliable, and ready to hold the essentials

____

See below for SPECS.

This STL file may be uploaded to your 3d printer slicer of choice.

Specs:

Dimensions

214mm (L)

102mm (W)

120mm (H)

Cup opening diameter: 93mm or 3.6in

Estimated 3d FFF material usage: 580 Grams

Recommended to complete 2 separate prints for TOP and Bottom. Screws (M6 16-25mm screws will be required for assembly. Final connection to the vehicle may be achieved via Sheet metal screw through bottom of cup holder OR temporary install using an inch wide bar stock on the bottom of the unit as shown in photos.

I’ve also supplied a combined version to use if desired for screwless assembly.